DAYNA COMMUNICATIONS, INC. SCSI/LINK-3, SCSI/LINK-3 PB Card Type Network Interface Card NIC Type Ethernet Maximum Onboard Memory Unidentified Boot ROM Not available Network Transfer Rate 10Mbps Topology Linear Bus, Star Wiring Type Unshielded twisted pair AUI transceiver via DB-15 port RG-58A/U 50ohm coaxial Data Bus SCSI [Image] CONNECTIONS Function Label Function Label RJ-45 connector CN1 25-pin SCSI CN4 connector - input AUI transceiver via CN2 25-pin SCSI CN5 DB-15 connector - output BNC connector CN3 DC Power connector CN6 Note: Connectors CN4 & CN5 allow SCSI/Link to be daisy-chained with other devices. USER CONFIGURABLE SETTINGS Function Label Position » SCSI/Link termination switch enabled SW1 On SCSI/Link termination switch disabled SW1 Off Note: If the SCSI/Link is not the last device in the SCSI chain, the internal termination switch must be turned off. SCSI ID SELECTION ID SW2 0 0 1 1 2 2 » 3 3 4 4 5 5 6 6 7 7 DIAGNOSTIC LED(S) LED Color Status Condition Power Amber On Power is on Power Amber Off Power is off Activity Green On Data is being transmitted/received Activity Green Off Data is not being transmitted/received Activity Red On Error condition Link status Green On UTP link is good Link status Green Off UTP link is broken MISCELLANEOUS TECHNICAL NOTES The SCSI/Link-3 comes with a 25-pin to 25-pin SCSI cable that connects to Desktop Macintosh computers. The SCSI/Link-3PB comes with a 30-pin to 25-pin cable that connects to Powerbook Macintosh computers. Additional cables are available from manufacturer.